Vintage Vantage Diver Watch w/All SS Case,ST 173 Mvmt,Runs FOR PARTS/REPAIR

Description

***********FOR REPAIR - while the time can be set and seconds hand will move for varying lengths of time after the watch has been gently spun face down on a flat surface (after recently spinning it nonstop for approximately one minute I observed the movement run and keep time for a little more than 2 hours), the crown does not engage the movement when being wound.  Considering the movement's unknown service history (there are no visible watchmaker service markings on the inside of the case back or on the movement) a complete overhaul is required.***********
This unique and seldom seen Vantage diver has a glossy black dial that
shows wear and chipping along the edge from approximately 12:05 to 2:12 o'clock.  Please note that a significant amount of dust/debris is sitting on the underbelly of the crystal and to a lesser degree the dial.
The lume on the dial, which has aged to a lighter patina than that of the hands, does not glow when exposed to bright light whereas the hands emit a quick-burst glow.  The bezel,
which does not rotate
, presents as near perfect in person (
the smudge at the beginning of the red section to the left of the 15 mark was noticed after taking the pictures and wiped off without issue
).  The all stainless steel case is in wonderful condition showing minor wear, no visibly noticeable dents or dings and no signs of oxidation.  The outer edge of the case back is stamped "SHOCKRESISTANT   WATERRESISTANT   ALL STAINLESS STEEL" with "TESTED TO A DEPTH OF 600 FEET   100% WATERPROOF AND CONDENSATION PROOF" stamped along the inner edge.  The inside of the case back is stamped "CONDE CO." followed by "CASE MADE IN HONG KONG."
The crystal shows scratching.
The 17 jewels ST 173 automatic movement is clean but
does not run as it should
.  While the time can be set and the movement will run for varied amounts of time after the watch has been gently spun face down on a flat surface,
the crown does not engage the movement when being wound.
Given this and considering the movement's unknown service history (there are no visible watchmaker service markings on the inside of the case back or on the movement),
a complete overhaul is required.
This watch measures approximately 37 mm excluding the crown, approximately 40 mm including the crown and approximately 18 mm between the lugs.  Case thickness, measured from the bottom of the case back to the top of the bezel, is approximately 10.5 mm.  Including the crystal thickness measures approximately 12.5 mm.
Given that the movement does not run as it should and considering its unknown service history a complete overhaul is required.
As such there are no warranties, express or implied, attached with the sale of this watch.  Vintage means old and while my personal belief is that old-school means better quality and workmanship, things can and do go wrong from time to time.
For this watch that time is now.  Any servicing costs going forward are your responsibility.
Please thoroughly read this entire listing and kindly ask any and all questions you may have prior to buying as this sale is final and no refunds of any kind will be given.  And please study the 12 high magnification pictures carefully, which were taken in natural light and from various angles, as they are part of the description and serve as an accurate representation of the condition of this watch.
Expedited and insured shipping will be provided.  Thanks for looking!
***********FOR REPAIR - while the time can be set and seconds hand will move for varying lengths of time after the watch has been gently spun face down on a flat surface (after recently spinning it nonstop for approximately one minute I observed the movement run and keep time for a little more than 2 hours), the crown does not engage the movement when being wound.  Considering the movement's unknown service history (there are no visible watchmaker service markings on the inside of the case back or on the movement) a complete overhaul is required.***********